Grip Studs Screw-In Tire Studs | Traction in Ice, Snow and Dirt | 1740 Tire Stud

Helpful Tips
When installing Grip Studs® with the Grip Studs® driver tool, ensure the prongs on your tool are firmly seated in the notches in the studs. If the tool is not seated all the way in the stud, torque pressure can cause the installation tool to break. Grip Studs® tools are not designed to be used with impact drivers.

Grip Studs® 1740 Screw-In Tire Stud
For control, efficiency, safety and just plain fun, dominate your terrain with tough, dependable Grip Studs®. These wide–auger traction studs have holding power like no other screw-in tire stud. Grip Studs® tungsten-carbide construction, beefy design and easy installation put them in a class of their own. Varying depths and lengths ensure you'll experience ultimate traction from tires or boot soles on ice, snow, mud, slimy rocks, ocean vegetation or frozen pavement. Grip Studs® − unquestionably the best screw-in traction studs you can buy!
Read customer reviews here
Ordering Info:

Pack of 100 Studs: $113.25

This product requires a tool!

Pack of 150 Studs: $167.85

This product requires a tool!

Carton of 1,000 Studs: $1076.35

This product requires a tool!

Tools for #1740

#4700 Power Install Tool: $10.25

Tire Stud #1740 Description:
•Easy-to-install Grip Studs® for tires, tracks and soles.

•Durable Tungsten Carbide performance tip and core.

•Wide-auger threads hold tire studs in place; Grip Studs® won't back out.

•Notched for easy installation and removal.

•Wide selection of sizes to fit most tires and soles.

• For recommended number of tire studs per tire, select category from the top toolbar above.

Installation and removal tools for use in power drills.
Technical Info:
Application Motorcycle
Dimensions 7.7 x 17.4 mm
(from tire or tread surface)
5.4 mm
Stud Penetration
(into tire or tread surface)
12 mm
Minimum Tread Depth 9.5 mm
Carbide Tip Width 2.2 mm
Corresponding Tool #4700 Install Tool
INSTALLATION INSTRUCTIONS: Always check tire tread depth before installing Grip Studs®. Attach install tool to variable speed drill. Snap a stud into the tip of the install tool. Position stud firmly against a thick knob of the tire tread. Firmly apply pressure straight down while slowly screwing the stud into the tire until the prongs on the tool are buried into the rubber. Remove the tool from the stud. The notched collar on the stud should be flush with the rubber. Studs may come out if they are not adequately sunk into the rubber. Repeat procedure for all studs. For optimum traction, install studs in varied pattern (not in a straight line) on the tread so the studs can make better contact with the terrain. Caution: Studs may damage or mar floors, truck beds and other surfaces.