Tire Studs Info | Grip Studs® Screw-In Tire Studs | Traction in Ice, Snow and Dirt | Technical Info


Helpful Tips
When installing Grip Studs® with the Grip Studs® driver tool, ensure the prongs on your tool are firmly seated in the notches in the studs. If the tool is not seated all the way in the stud, torque pressure can cause the installation tool to break. Grip Studs® tools are not designed to be used with impact drivers.

Home |Stud Technical Information
Grip Studs® Technical Info
Tire Stud Application
Grip Studs® Features and BenefitsGrip Stud Cut Away




Grip Studs Bullet PointWide-Auger Threads
Patented wide-auger threads allow more surface area to contact the rubber, increasing retention and preventing movement further into or out of the rubber. No glue necessary.
Grip Studs Bullet PointTungsten Carbide
Solid tungsten carbide core ensures strength and durability.
Grip Studs Bullet Point Easy Installation
Installation tools fit into variable-speed drills, allowing easy installation and removal. No complicated stud gun, pre-drilled holes, or glue required. Manual driver and handle tools available for manual installation in boots, bicycles, etc. Note: Do not install Grip Studs® with impact tools; use variable speed drills only. Installation Guide
Grip Studs Bullet PointVariety of Stud Sizes
Grip Studs® varied thread depths and tip lenghts fit a wide range of tire, tracks, and footwear applications requiring traction on ice, snow, mud, ocean vegetation or frozen pavement
Grip Studs Bullet PointShop by Category or Specific Stud
We make choosing the right stud simple - you can either shop by category from the toolbar categories at the top of the page, or shop by specific stud from the Stud Selection Guide. Still have questions? Give us a call toll-free at 855-538-7883 or 541-476-1928.



INSTALLATION INSTRUCTIONS: Always check tire tread depth before installing Grip Studs®. Attach install tool to variable speed drill. Snap a stud into the tip of the install tool. Position stud firmly against a thick knob of the tire tread. Firmly apply pressure straight down while slowly screwing the stud into the tire until the prongs on the tool are buried into the rubber. Remove the tool from the stud. The notched collar on the stud should be flush with the rubber. Studs may come out if they are not adequately sunk into the rubber. Repeat procedure for all studs. For optimum traction, install studs in varied pattern (not in a straight line) on the tread so the studs can make better contact with the terrain. Caution: Studs may damage or mar floors, truck beds and other surfaces.

HOME CONTACT US VIEW SHOPPING CART COPYRIGHT© 2012 GRIP STUDS® Merlin OR 97532 USA 541-476-1928 |SiteLock
The free script slideshow was provided by JavaScript Kit